AltBerg Footbeds Trim To Fit Advice
(First check the old footbed is a good fit) Remove old footbed from the boot
If the old footbed is a good fit, use it to mark the Svartz footbed trimming line
The line should be clearly marked.
Add a little bit if the old footbed was too small. Reduce a little bit if the old footbed was too tight
Use scissors to trim the Svartz footbed to the required size
Don't cut too much - a full half size is only 6mm! If unsure, trim a bit at a time, you can always cut a little bit more off - but you can't add it back on again
Put the trimmed footbed into the boot to replace the old footbed. CHECK THE FIT -if it is still too tight, mark and trim a little more