AltBerg Svartz Memorex Foot beds, Memory Foam which adapts to your foot.

Heel & Forefoot Pressure Cushioned & Spread, reducing impact on knees and ankles
Maximum 3 Dimensional Underfoot Shape to support heel and ankle alignment
Balanced Heel Strike reduces impact and improves heel and ankle stabilisation

Svartz® Memorex Foot beds

The latest foot bed in the Svartz® range. The Memorex foot bed is constructed using a layer of memory foam, which will adapt to the users foot absorbing and spreading the pressure under the foot when running, tabbing or walking.

This is an excellent foot bed for people who require a balance between good support and comfort. Memorex is suitable for a range of footwear which have removable insoles, from trail running shoes to high end military/walking boots.

Covering – Anti bacterial micro covering,

Forefoot thickness – 4.5mm

Centre heel thickness – 6mm

Memory foam insert of 2mm through whole foot bed,

(Patent pending)

Alt-Berg Svartz® Memorex Foot beds

Washable at 30 degrees
Sweat Absorb
Memory Foam Layer
Shock Absorption
Flexible
Ankle Underfoot Support
Better Weight Distribution
Improved Stabilisation

WASHING INSTRUCTIONS

Clean by rubbing gently with a sponge, hot water, and normal soap, then rinse the foot bed surface under a running tap.  This will help flush out any perspiration salts which may have been absorbed into the foot bed fabric.

In extreme conditions, the Anatomic Absorber foot bed may be machine washed – maximum temperature 30°C

DRYING INSTRUCTIONS

Allow to dry naturally in a cool place.

Do not put near heat

Do not dry on a radiator

Do not tumble dry

Do not dry in sunlight

Heat will damage the footbeds.

If your boot size is a half size, buy the next size up and trim to fit the foot bed as per the included instruction.

AltBerg Footbeds Trim To Fit Advice

STEP ONE

(First check the old foot bed is a good fit) Remove old foot bed from the boot  

 

 

STEP TWO

If the old foot bed is a good fit, use it to mark the Svartz foot bed trimming line

 

 

STEP THREE

The line should be clearly marked.
Add a little bit if the old foot bed was too small. Reduce a little bit if the old foot bed was too tight  



STEP FOUR

Use scissors to trim the Svartz foot bed to the required size



STEP FIVE

Don't cut too much - a full half size is only 6mm! If unsure, trim a bit at a time, you can always cut a little bit more off - but you can't add it back on again



STEP SIX

Put the trimmed foot bed into the boot to replace the old foot bed. CHECK THE FIT -if it is still too tight, mark and trim a little more